PRODUCT
Drawing
Dimensions
Model No. M(mm) W(mm) L(mm) Mass(kg)
SRS 5M 6 12 16.9 0.002
SRS 5GM 6 12 16.9 0.002
SRS 5N 6 12 20.1 0.003
SRS 5GN 6 12 20.1 0.003
SRS 7S 8 17 19 0.005
SRS 7GS 8 17 19 0.005
SRS 7M 8 17 23.4 0.009
SRS 7GM 8 17 23.4 0.009
SRS 7N 8 17 31 0.012
SRS 7GN 8 17 31 0.012
SRS 9XS 10 20 21.5 0.009
SRS 9XGS 10 20 21.5 0.009
SRS 9XM 10 20 30.8 0.016
SRS 9XGM 10 20 30.8 0.016
SRS 9XN 10 20 40.8 0.024
SRS 9XGN 10 20 40.8 0.024
SRS 12S 13 27 25 0.017
SRS 12GS 13 27 25 0.017
SRS 12M 13 27 34.4 0.027
SRS 12GM 13 27 34.4 0.027
SRS 12N 13 27 47.1 0.049
SRS 12GN 13 27 47.1 0.049
Note
Note) Since stainless steel is used in the LM block, LM rail and balls, these models are highly resistant to corrosion and environment.
The SRS-G is equipped with uncaged, full-complement bearings.
Using a greasing hole other than for greasing may cause damage.
Note1) The maximum length under “Length ＊ ” indicates the standard maximum length of an LM rail. (See A1-164 .)
Static permissible moment ＊ 1 block: the static permissible moment with one LM block
Double blocks: static permissible moment when two LM blocks are in close contact with each other
Total block length L : The total block length L shown in the table is the length with the dust proof parts, code UU or SS.
If other contamination protection accessories or lubricant equipment are installed, the
total block length will increase.
For the SRS5M and SRS5N LM guide, the balls will fall out of the block if it is removed from the rail.
To secure the LM rail of model SRS5M, use cross-recessed head screws for precision equipment (No. 0 pan head screw, class 1) M2.
Note2) The basic load rating in the dimension table is for a load in the radial direction. Use Table7 on A1-60 to calculate
the load rating for loads in the reverse radial direction or lateral direction.
Model
