PRODUCT
THK LM Guide SHS V
V:With this type, the LM block has a smaller width (W) and tapped holes. Used in places where the space for table width is limited.
LV:The LM block has the same cross-sectional shape as model SHS-V, but has a longer overall LM block length (L) and a greater rated load.
Drawing
Dimensions
Model No. M(mm) W(mm) L(mm) LM block(kg)
SHS15V 24 34 64.4 0.19
SHS20V 30 44 79 0.35
SHS25V 36 48 92 0.54
SHS30V 42 60 106 0.94
SHS35V 48 70 122 1.4
SHS45V 60 86 140 2.54
SHS55V 70 100 171 4.05
SHS65V 90 126 221 8.41
Model No. M(mm) W(mm) L(mm) LM block(kg)
SHS15VM 24 34 64.4 0.19
SHS20VM 30 44 79 0.35
SHS25VM 36 48 92 0.54
Model No. M(mm) W(mm) L(mm) LM block(kg)
SHS15LV 24 34 79.4 0.22
SHS20LV 30 44 98 0.46
SHS25LV 36 48 109 0.67
SHS30LV 42 60 131 1.16
SHS35LV 48 70 152 1.84
SHS45LV 60 86 174 3.19
SHS55LV 70 100 213 5.23
SHS65LV 90 126 272 10.7
Model No. M(mm) W(mm) L(mm) LM block(kg)
SHS15LVM 24 34 79.4 0.22
SHS20LVM 30 44 98 0.46
SHS25LVM 36 48 109 0.67
Note
Note) The maximum length under “Length ＊ ” indicates the standard maximum length of an LM rail. (See A1-104 .)
Static permissible moment ＊ 1 block: the static permissible moment with one LM block
Double blocks: static permissible moment when two LM blocks are in close contact with each other
Total block length L : The total block length L shown in the table is the length with the dust proof parts, code UU or SS.
If other contamination protection accessories or lubricant equipment are installed, the
total block length will increase. (See A1-507 or A1-528)
＊＊ A pilot hole for side nipples, when a grease nipple for a model equipped with LaCS or QZ Lubricator is needed.
Pilot holes for side nipples are not drilled through for models other than those stated above.
For grease nipple mount machining, contact THK.
Model
