THK LM Guide HSH C Models SHS-C, SHS-CM, SHS-LC and SHS-LCM

Drawing

Dimensions

Model             H(mm)  W(mm)  L(mm)  LM block(kg)

SHS 15LCM          24        47         79.4         0.29

SHS 20LCM           30        63          98          0.61

SHS 25LCM           36        70          109         0.89

Note

Note) The maximum length under “Length ＊ ” indicates the standard maximum length of an LM rail. (See A1-104 .)

 Static permissible moment ＊ 1 block: the static permissible moment with one LM block 

Double blocks: static permissible moment when two LM blocks are in close contact with each other

 Total block length L : The total block length L shown in the table is the length with the dust proof parts, code UU or SS. 

If other contamination protection accessories or lubricant equipment are installed, the 

total block length will increase. (See A1-507 or A1-528)

＊＊ A pilot hole for side nipples, when a grease nipple for a model equipped with LaCS or QZ Lubricator is needed. 

 Pilot holes for side nipples are not drilled through for models other than those stated above. 

 For grease nipple mount machining, contact THK.

Model

[email protected]