THK LM Guide SHS CM

Drawing

Dimensions

Model          H(mm)  W(mm)  L(mm)  LM block(kg)

SHS 15CM           24        47         64.4        0.23

SHS 20CM           30        63          79          0.46

SHS 25CM           36        70          92          0.72

Note

Note) The maximum length under “Length ＊ ” indicates the standard maximum length of an LM rail. (See A1-104 .)

 Static permissible moment ＊ 1 block: the static permissible moment with one LM block 

Double blocks: static permissible moment when two LM blocks are in close contact with each other

 Total block length L : The total block length L shown in the table is the length with the dust proof parts, code UU or SS. 

If other contamination protection accessories or lubricant equipment are installed, the 

total block length will increase. (See A1-507 or A1-528 )

＊＊ A pilot hole for side nipples, when a grease nipple for a model equipped with LaCS or QZ Lubricator is needed. 

 Pilot holes for side nipples are not drilled through for models other than those stated above. 

 For grease nipple mount machining, contact THK.

Model

[email protected]